SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 4 (ENGINE CONTROLS AND FUEL - 2.2L (L61) - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSAIR CLEANER ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2008 Chevrolet HHR LT, 2.4 P, Automatic

Installation Procedure

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Installation Procedure
WARNING: This page is about a different variant/trim than selected.
    Fig 1: Air Cleaner Assembly
    GM1638524Courtesy of GENERAL MOTORS CORP.
  1. Install the air cleaner assembly.
    2. NOTE: Refer to Fastener Notice .
  2. Tighten the air cleaner outlet duct clamp at the throttle body.

    Tighten:  Tighten the clamp to 5 N.m (44 lb in).

    3. Fig 2: MAF Sensor Electrical Connector
    GM1625474Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
    4. Fig 3: PCV Hose
    GM1721513Courtesy of GENERAL MOTORS CORP.
  4. Install the PCV hose (2) to the air cleaner assembly.
  5. Position the PCV hose clamp (1) at the air cleaner assembly.
  6. Seat the air cleaner assembly onto the studs.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.