SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 98 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM & NAVIGATION SYSTEM)REPAIR INSTRUCTIONSANTENNA CABLE REPLACEMENT
2008 Chevrolet HHR LT, 2.4 P, Automatic

Antenna Cable Replacement

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Antenna Cable Replacement
WARNING: This page is about a different car, the 2009 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Antenna Cable
GM1614265Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Lower the front of the headliner. Refer to Headlining Trim Panel Replacement .
  2. Remove the windshield pillar molding. Refer to Windshield Garnish Molding Replacement .
  3. Remove the left instrument panel insulator. Refer to Instrument Panel Insulator Replacement .
1 Radio Antenna Cable Assembly
Tip:  Disconnect the cable at the antenna and at the instrument panel.
2 Radio Antenna Cable Clip
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.