Instrument Panel/Center Console Component Views

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Instrument Panel/Center Console Component Views
WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying I/P Components
GM1825386Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Instrument Panel Cluster (IPC)
2 Ambient Light Sensor
3 Hazard Switch
4 Radio
5 Remote Control Door Lock Receiver (RCDLR) (AUO)
6 Heated Seat Switch - Passenger (KA1)
7 HVAC Control Module
8 Body Control Module (BCM)
9 Heated Seat Switch - Driver (KA1)
10 I/P Dimmer Switch
11 Fog Lamp Switch (T37)
12 Data Link Connector (DLC)
13 Rear Compartment Lid Release Switch
14 I/P Trim
Fig 2: Identifying Instrument Panel Components
GM2034609Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Remote Control Door Lock Receiver (RCDLR) (AUO)
2 Ambient Light Sensor
3 Brake Pedal Position Sensor
4 Audio Amplifier (UQ3)
5 Data Link Connector (DLC)
6 Clutch Pedal Position (CPP) Sensor (M86/MU3)
7 Body Control Module (BCM)
8 Accelerator Pedal Position (APP) Sensor
Fig 3: View Of Steering Column
GM2034789Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Theft Deterrent Control Module
2 Steering Angle Sensor (JL4)
3 Power Assist Motor
Fig 4: View Of Steering Wheel
GM2034613Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Steering Wheel Controls - Left (UK3)
2 Inflatable Restraint Steering Wheel Module
3 Steering Wheel Controls - Right (UK3)
Fig 5: View Of Interior HVAC Components
GM1543938Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 HVAC Box Assembly
2 Blower Motor Resistor
3 Blower Motor
4 Recirculation Actuator
5 Mode Actuator
6 Air Temperature Actuator
Fig 6: View Of Console Components
GM1543930Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Console Armrest
2 Cigar Lighter (DT4), Auxiliary Power Outlet (- DT4)
3 Auxiliary Power Outlet - Console
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.