Radiator Inlet Hose Replacement

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Radiator Inlet Hose Replacement
WARNING: This page is about a different car, the 2011 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Radiator Inlet Hose
GM1616717Courtesy of GENERAL MOTORS COMPANY
Radiator Inlet Hose Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement
  2. Partially drain the cooling system. Refer to Cooling System Draining and Filling (GE 47716 Fill) , Cooling System Draining and Filling (Static Fill-LE8, LE9) .
1 Radiator Cap
2 Coolant Recovery Reservoir Hose
TIP:  Only remove the coolant recovery reservoir hose from the radiator fill neck tube.
3 Radiator Inlet- Front Hose
Procedure 
Use J 38185 to reposition hose on the radiator inlet hose.
Special Tools 
J 38185 Hose Clamp Pliers
4 Radiator Fill Tube Neck
5 Radiator Inlet- Rear Hose
Procedure 
Use J 38185 to reposition hose on the radiator inlet hose.
Special Tools 
J 38185 Hose Clamp Pliers
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.