Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 621 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2008 Chevrolet HHR LT, 2.4 P, Automatic
Fastener Tightening Specifications
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2011 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Amplifier Screw | 9 N.m | 80 lb in |
| Communication Interface Module Battery Nut | 10 N.m | 89 lb in |
| Communication Interface Module Nut | 10 N.m | 89 lb in |
| Digital Radio Antenna Bolt | 9 N.m | 80 lb in |
| Digital Radio Receiver Nut | 10 N.m | 89 lb in |
| Door Speaker Screw | 3 N.m | 25 lb in |
| Heater and A/C Control Module Screw | 2 N.m | 18 lb in |
| Mobile Telephone and Vehicle Location Antenna Bolt | 9 N.m | 80 lb in |
| Quarter Inner Trim Panel Bracket Screw | 10 N.m | 89 lb in |
| Radio Antenna Bolt | 9 N.m | 80 lb in |
| Radio Assembly Screw | 2 N.m | 18 lb in |
| Radio Rear Speaker Housing Nut | 9 N.m | 80 lb in |
| Radio Speaker Windshield Garnish Molding Screw | 2 N.m | 18 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.