Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 613 (SEAT BELT SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2008 Chevrolet HHR LT, 2.4 P, Automatic
Fastener Tightening Specifications
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2011 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Child Seat Tether Bracket Bolts | 40 N.m | 30 lb ft |
| Front Seat Belt Anchor Plate Bolt | 43 N.m | 32 lb ft |
| Front Seat Belt Buckle Nut | 40 N.m | 30 lb ft |
| Front Seat Belt Retractor Bolt | 43 N.m | 32 lb ft |
| Front Shoulder Belt D Ring Bolt | 42 N.m | 31 lb ft |
| Front Shoulder Belt Guide Adjuster Bracket Bolts | 50 N.m | 37 lb ft |
| Rear Seat Center Belt Anchor Nut | 45 N.m | 33 lb ft |
| Rear Seat Center Buckle Nuts | 45 N.m | 33 lb ft |
| Rear Seat Center Retractor Bolt. | 43 N.m | 32 lb ft |
| Rear Seat Retractor Bolts. | 43 N.m | 32 lb ft |
| Rear Seat Shoulder Belt D Ring Bolt. | 43 N.m | 32 lb ft |
| Rear Shoulder Belt Anchor Plate Bolt | 43 N.m | 32 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.