Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 606 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WIPER MOTOR REPLACEMENT

2008 Chevrolet HHR LT, 2.4 P, Automatic

Windshield Wiper Motor Replacement

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Windshield Wiper Motor Replacement

WARNING: This page is about a different car, the 2011 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Windshield Wiper Motor

Courtesy of GENERAL MOTORS COMPANY

Windshield Wiper Motor Replacement

Callout

Component Name

Preliminary Procedures

Remove the wiper transmission assembly. Refer to Windshield Wiper Transmission Replacement .
Disconnect the wiper motor electrical connector.

Windshield Wiper Motor Bolt (Qty: 3)

CAUTION:

Refer to Fastener Caution .

Tighten
6 N.m (53 lb in)

Windshield Washer Wiper Motor

Procedure

Do not apply electrical power to a new wiper motor prior to installation of that motor.
Use the J 39232 or equivalent to separate the transmission arm from the wiper motor crank arm pivot.
Use the J 39529 or equivalent to install the transmission arm onto the wiper motor crank arm pivot.
Align the wiper motor crank arm in alignment with the transmission arm links.

Special Tools

J 39232 Wiper Linkage Separator
J 39529 Wiper Linkage Installer

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.