Installation Procedure

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2011 GMC Canyon and 2011 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Temperature Control Cable & Temperature Actuator Cam
    GM1273250Courtesy of GENERAL MOTORS CORP.
  1. Install the temperature cable (4).
  2. Install the temperature control cable (9) to the temperature actuator cam (10).
  3. Install the temperature cable to the retaining clip.
  4. Fig 2: View Of Temperature Cable & Mode Cable
    GM1273258Courtesy of GENERAL MOTORS CORP.
  5. Install the temperature cable (4) to the temperature control cam (5).
  6. Install the temperature cable (4) to the retaining clip.
  7. CAUTION: Refer to Fastener Caution .
  8. Install the mounting screws to the HVAC control assembly. Tighten the screws to 1.9 N.m (17 lb in).
  9. Install the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.