Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 52 (SUNROOF SYSTEM)REPAIR INSTRUCTIONSSUNROOF WINDOW REPLACEMENTINSTALLATION PROCEDURE

2008 Chevrolet HHR LT, 2.4 P, Automatic

Installation Procedure

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Sunroof Window & Screws

Courtesy of GENERAL MOTORS CORP.

Position the sunroof window into the opening.
Ensure that the window trade mark is to the rear of the opening and that sunroof window attachment tabs are to the inboard side of the mounting arms.

NOTE: Refer to Fastener Notice .

Install the sunroof window screws (1) to the window. Do not tighten the screws.
Tighten: Tighten the screws to 4 N.m (35 lb in).
Carefully close the sunroof window from the vent position to the full closed position.
Adjust the sunroof window. Refer to Sunroof Window Height and Opening Fit Adjustment .
Close the sunshade.
Cycle the sunroof window to ensure proper operation and fit.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.