Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 516 (CRUISE CONTROL SYSTEM)REPAIR INSTRUCTIONSCRUISE CONTROL RELEASE SWITCH REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet HHR LT, 2.4 P, Automatic
Removal Procedure
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2011 GMC Canyon and 2011 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the electrical connector from the cruise release switch.
- Complete the following in order to remove the cruise release switch from the brake pedal bracket:
- Rotate the switch counter clockwise.
- Pull the switch from the retainer.
- Push the locking tabs inward to release the retainer.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.