Installation Procedure

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2011 GMC Canyon and 2011 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left Differential Carrier Mounting Bracket
    GM1339811Courtesy of GENERAL MOTORS CORP.
  1. Lift the front differential into position.
  2. Install the mounting bracket to the differential housing. Refer to Front Differential Carrier Bushing and Bracket ReplacementΒ .
  3. Fig 2: View Of Vent Hose At Front Differential Housing
    GM1305845Courtesy of GENERAL MOTORS CORP.
  4. Install the vent hose.
  5. Fig 3: View Of Electric Motor Actuator
    GM1347767Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.