SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 505 (DISC BRAKE SYSTEM)REPAIR INSTRUCTIONSBRAKE CALIPER BRACKET REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet HHR LT, 2.4 P, Automatic

Removal Procedure

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2011 GMC Canyon and 2011 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Refer to Brake Dust Warning .
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    3. CAUTION: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.
  3. Without disconnecting the front brake hose, remove the brake caliper and support with heavy mechanics wire or equivalent. Refer to Brake Caliper Replacement .
  4. Remove the disc brake pads from the brake caliper bracket.
    5. Fig 1: Brake Caliper Mounting Bracket Mounting Bolts
    GM1241469Courtesy of GENERAL MOTORS CORP.
  5. Remove the 2 brake caliper bracket bolts.
    6. Fig 2: Brake Caliper Mounting Bracket
    GM1241358Courtesy of GENERAL MOTORS CORP.
  6. Remove the brake caliper bracket.
  7. Inspect the disc brake hardware for damage and replace, if necessary. Refer to Disc Brake Mounting and Hardware Inspection .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.