Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 501 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSHEADLAMP REPLACEMENTINSTALLATION PROCEDURE
2008 Chevrolet HHR LT, 2.4 P, Automatic
Installation Procedure
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2011 GMC Canyon and 2011 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the electrical connector to the bulb.
- Push in and rotate the park lamp (1), high beam headlamp (2), low beam headlamp (3), or the DRL, Park and turn signal, and front side marker bulb 1/4 turn clockwise in order to install the bulb.
- Install the bolts that retain the headlamp.
Tighten: Tighten the bolts to 10 N.m (89 in lb).
- Inspect the headlamps for proper operation.
- Install the front grille. Refer to Grille Replacement .
- Aim the headlamps. Refer to Headlamp Aiming .
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.