Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 497 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2008 Chevrolet HHR LT, 2.4 P, Automatic
Fastener Tightening Specifications
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2011 GMC Canyon and 2011 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Endgate Handle Bolts | 9 N.m | 80 lb in |
| Endgate Latch Bolts | 25 N.m | 18 lb ft |
| Endgate Striker Bolts | 25 N.m | 18 lb ft |
| Endgate Handle Lock Cylinder Bolts | 9 N.m | 80 lb in |
| Front Door Latch Bolts | 9 N.m | 80 lb in |
| Front Door Latch Screws | 7 N.m | 62 lb in |
| Front Door Switch Plate Screws | 2 N.m | 18 lb in |
| Front Door Outside Handle Bolts | 9 N.m | 80 lb in |
| Front Door Outside Handle Cylinder Bolt | 9 N.m | 80 lb in |
| Front Door Striker Screws | 25 N.m | 18 lb ft |
| Rear Door Latch Bolts | 9 N.m | 80 lb in |
| Rear Door Latch Screws | 7 N.m | 62 lb in |
| Rear Outside Access Door Latch | 9 N.m | 80 lb in |
| Rear Outside Door Handle Bolts | 9 N.m | 80 lb in |
| Rear Side Access Door Lower Latch Nuts | 9 N.m | 80 lb in |
| Rear Side Access Door Lower Latch Bolts | 9 N.m | 80 lb in |
| Rear Side Access Door Lower Latch Bolts | 9 N.m | 80 lb in |
| Rear Side Access Door Lower Striker Bolts | 25 N.m | 18 lb ft |
| Rear Side Access Door Upper Striker Bolts | 25 N.m | 18 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.