Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 497 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)REPAIR INSTRUCTIONSLATCH CONTROL ASSEMBLY REPLACEMENT REAR SIDE ACCESS DOORREMOVAL PROCEDURE

2008 Chevrolet HHR LT, 2.4 P, Automatic

Removal Procedure

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Removal Procedure

WARNING: This page is about a different car, the 2011 GMC Canyon and 2011 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Open the rear side access door.
Remove the rear side access door trim panel. Refer to Rear Side Access Door Trim Panel Replacement .
Remove the rear side access door latch control handle. Refer to Rear Side Access Door Inside Handle Replacement .

Fig 1: View Of Latch Control Assembly

Courtesy of GENERAL MOTORS CORP.

Disconnect the upper latch rod (1) from the control assembly by releasing the retaining clip (2).
Disconnect the lower latch rod from the control assembly by releasing the retaining clip (3).
Remove the bolts retaining the latch control assembly from the rear side access door.
Remove the latch control assembly from the rear side access door.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.