Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 497 (POWER DOOR LOCK SYSTEM AND RELEASE SYSTEMS)REPAIR INSTRUCTIONSENDGATE LATCH AND CABLE ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE

2008 Chevrolet HHR LT, 2.4 P, Automatic

Installation Procedure

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Canyon and 2011 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Latch/Support Cable Assembly

Courtesy of GENERAL MOTORS CORP.

Install the latch/support cable assembly to the endgate, ensuring the latch rod is oriented correct to the endgate handle.

CAUTION: Refer to Fastener Caution .

Install the bolts retaining the latch assembly to the endgate.
Tighten: Tighten the latch/support cable assembly bolts to 25 N.m (18 lb ft).

Fig 2: View Of Endgate Support Cables

Courtesy of GENERAL MOTORS CORP.

Install the support cable (1) onto the bolt head of the endgate striker bolt.

Fig 3: View Of Latch Rods & Retaining Clips

Courtesy of GENERAL MOTORS CORP.

Install the latch rods (2) into the retaining clips (1).
Connect the clips (1) retaining the latch rods (2) to the endgate handle.
Install the endgate cover. Refer to Pickup Box Endgate Latch Cover Replacement .
Close the endgate.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.