SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 49 (DATA COMMUNICATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DOES NOT COMMUNICATE WITH LOW SPEED GMLAN DEVICECIRCUIT/SYSTEM TESTING
2008 Chevrolet HHR LT, 2.4 P, Automatic

Circuit/System Testing

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the low speed splice pack.
  2. Ignition ON, test for less than 1.0 volt between the low speed GMLAN serial data circuit of the DLC and ground.
    • If greater than 1.0 volt, repair the serial data circuit for a short to voltage.
  3. Test for infinite resistance between the serial data circuit of the DLC and ground.
    • If less than infinite resistance, repair the serial data circuit for a short to ground.
  4. Test for less than 1.0 ohm of resistance in the serial data circuit between the DLC and the splice pack.
    • If greater than 1.0 ohm, repair the serial data circuit for an open/high resistance.
  5. Install a 3-amp fused jumper wire between pin A and pin M of the splice pack. Install another 3-amp fused jumper wire to pin M.
  6. Using the extra jumper wire from pin M attempt to establish communications with any other module connected to the splice pack. At least one module should be able to communicate.
    • If communications can't be established with any module, test the serial data circuit of the BCM for a short to voltage, short to ground or open/high resistance. If the circuit tests normal, replace the BCM.
  7. Using the extra jumper wire at pin M, continue testing each serial data circuit at the splice pack for communications. All modules should be able to communicate.
    • If there is only one module connected, test the serial data circuit for a short to voltage or a short to ground. If the circuit tests normal, replace the faulty module.
    • If there are multiple modules, test each serial data circuit for a short to voltage or a short to ground, with the modules disconnected. If the circuit tests normal, install each module one at a time starting with the closest module to the splice pack until communications stop. Replace the faulty module.
  8. If all circuits test normal, test or replace the splice pack.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.