Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 472 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PUMP FLOW CONTROL VALVE REPLACEMENT - OFF VEHICLEASSEMBLY PROCEDURE
2008 Chevrolet HHR LT, 2.4 P, Automatic
Assembly Procedure
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Assembly Procedure
WARNING: This page is about a different car, the 2011 GMC Canyon and 2011 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the flow control spring (2) to the hydraulic pump housing assembly (1).
- Install the control valve assembly (3).
- Lubricate the new O-ring seal (4) with power steering fluid.
- Install the O-ring seal (4) on to the O-ring union fitting (5).
- Install the O-ring union fitting (5) into the hydraulic pump housing assembly (1). Tighten the O-ring union fitting to 75 N.m (55 lb ft).
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.