Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 438 (COMPONENT LOCATIONS - INSTRUMENT PANEL/CENTER CONSOLE COMPARTMENT VIEWS)INSTRUMENT PANEL/CENTER CONSOLE COMPONENT VIEWS
2008 Chevrolet HHR LT, 2.4 P, Automatic
Instrument Panel/Center Console Component Views
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Instrument Panel/Center Console Component Views
WARNING: This page is about a different car, the 2010 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Theft Deterrent Control Module |
| Callout | Component Name |
|---|---|
| 1 | Steering Wheel Controls - Left |
| 2 | Steering Wheel Controls - Right |
| 3 | Horn Switch |
| Callout | Component Name |
|---|---|
| 1 | Turn Signal / Multifunction Switch |
| 2 | Inflatable Restraint Steering Wheel Module Coil |
| 3 | Windshield Wiper / Washer Switch |
| 4 | Ignition Lock Control Actuator (MN5) |
| 5 | Power Steering Control Module (PSCM) |
| 6 | Steering Angle Sensor |
| 7 | Electronic Power Steering (EPS) Motor |
| 8 | Ignition Switch |
| Callout | Component Name |
|---|---|
| 1 | A-Pillar Trim |
| 2 | Turbocharger Boost Gage (LNF) |
| Callout | Component Name |
|---|---|
| 1 | I/P Trim Panel |
| 2 | Instrument Panel Cluster (IPC) |
| 3 | G201 |
| 4 | G203 |
| Callout | Component Name |
|---|---|
| 1 | Ambient Light Sensor |
| 2 | Driver Information Center (UAF) |
| 3 | Hazard Switch |
| 4 | Inflatable Restraint I/P Module |
| 5 | Passenger Rear Access Panel Switch - Right Rear Panel (Panel Van) |
| 6 | Inflatable Restraint I/P Module Indicator |
| 7 | Radio/Navigation Unit |
| 8 | HVAC Control Assembly |
| 9 | Cigar Lighter (DT4)/Accessory Power Outlet I/P (- DT4) |
| 10 | Rear Wiper/Washer Switch |
| 11 | Fog Lamp Switch (T37 or T96) |
| 12 | Traction Control Switch |
| 13 | I/P Dimmer Switch |
| 14 | Steering Wheel Controls - Right (UK3) |
| 15 | Steering Wheel Controls - Left |
| 16 | Driver Rear Access Panel Switch - Left Rear Panel (Panel Van) |
| 17 | Driver Rear Access Panel Switch - Right Rear Panel (Panel Van) |
| 18 | Turn Signal/Multifunction Switch |
| 19 | Inflatable Restraint Steering Wheel Module |
| 20 | Instrument Panel Cluster (IPC) |
| 21 | WindshieldWiper/Washer Switch |
| Callout | Component Name |
|---|---|
| 1 | I/P Trim |
| 2 | Body Control Module (BCM) |
| 3 | Inflatable Restraint Vehicle Rollover Sensor |
| 4 | A/T Shift Lever (MN5) |
| 5 | YAW and Lateral Accelreometer Sensor |
| 6 | Floor Panel |
| 7 | Park Brake Switch |
| 8 | Inflatable Restraint Sensing and Diagnostic Module (SDM) |
| 9 | Floor Panel |
| Callout | Component Name |
|---|---|
| 1 | Automatic Transmission Shift Lever |
| 2 | Park Position Switch |
| 3 | X307 |
| 4 | Automatic Transmission Shift Lever Bulb and Socket |
| 5 | Automatic Transmission Shift Lock Control Solonoid |
| Callout | Component Name |
|---|---|
| 1 | Center Console |
| 2 | Auxiliary Power Outlet - Console |
| Callout | Component Name |
|---|---|
| 1 | HVAC Box Assembly |
| 2 | Blower Motor Resistor Assembly |
| 3 | Blower Motor |
| 4 | Recirculation Actuator |
| 5 | Air Temperature Actuator |
| 6 | Mode Actuator |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.