SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 358 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSTRUT ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet HHR LT, 2.4 P, Automatic

Removal Procedure

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2010 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle just high enough to remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  2. Remove the stabilizer shaft link from the front suspension strut. Refer to Stabilizer Shaft Link Replacement .
    3. Fig 1: View Of Front Suspension Strut Stud & Mounting Nut
    GM2003661Courtesy of GENERAL MOTORS CORP.
  3. Remove the front suspension strut mounting nut (1) on the front suspension strut stud (2).
  4. Raise the vehicle high enough to access the lower front suspension strut bolts.
  5. Support the lower control arm with a adjustable jack stand.
    6. Fig 2: View Of Front Suspension Strut Nut & Bolts
    GM2005976Courtesy of GENERAL MOTORS CORP.
  6. Remove the front suspension strut nut (2) from the front suspension strut bolts (5).
  7. Disconnect the wheel speed sensor electrical connectors (3) and (4).
  8. Remove the wheel speed sensor bracket (1), and relocate to the side.
    9. Fig 3: Identifying Front Suspension Strut & Bolts
    GM2005989Courtesy of GENERAL MOTORS CORP.
  9. Remove the front suspension strut bolts (2) from the front suspension strut (1).
    10. Fig 4: Identifying Front Suspension Strut
    GM2003673Courtesy of GENERAL MOTORS CORP.
  10. Remove the front suspension strut (2) from the vehicle (1).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.