Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 348 (CELLULAR SYSTEMS, ENTERTAINMENT SYSTEMS & NAVIGATION SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESRADIO POOR RECEPTIONCIRCUIT/SYSTEM TESTING
2008 Chevrolet HHR LT, 2.4 P, Automatic
Circuit/System Testing
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2010 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
Antenna Circuit Testing
- Disconnect the harness connector at the antenna.
- Radio ON, verify a test lamp illuminates between the entertainment remote enable signal circuit terminal 1, and ground.
- If test lamp does not illuminate, test the circuit for short to ground or an open/high resistance. If circuit tests normal, replace the radio.
- Disconnect the antenna coax from the radio and the radio antenna.
- Test for infinite resistance between the antenna coax center terminal and ground.
- If less than the specified value, replace the antenna coax.
- Test for less than 5 ohms of resistance on the antenna coax center terminal from end to end.
- If greater than the specified range, replace the antenna coax.
- Test for less than 5 ohms of resistance on the antenna coax outer shield from end to end.
- If greater than the specified range, replace the antenna coax.
- Test for infinite resistance between the coax center terminal and the outer shield.
- If less than the specified value, replace the antenna coax.
- If all circuits test normal, replace the antenna.
- Ignition ON, radio ON, verify radio reception has improved.
- If there is still poor reception, replace the radio.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.