Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 341 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSTAIL LAMP BULB REPLACEMENT

2008 Chevrolet HHR LT, 2.4 P, Automatic

Tail Lamp Bulb Replacement

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Tail Lamp Bulb Replacement

WARNING: This page is about a different car, the 2010 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tail Lamp Bulb

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Preliminary Procedure

Open the liftgate.
Remove either the LR or RR quarter trim panel access hole cover in order to access the rear tail lamp electrical connector.
Disconnect the rear tail lamp bulb electrical connector.

Tail Lamp Bulb Socket
Tip: Turn the lamp socket a quarter turn counterclockwise to remove from the tail lamp bracket.

Tail Lamp Bulb
Tip: Pull the tail lamp bulb straight from the socket.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.