Windshield Wiper Transmission Replacement

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Windshield Wiper Transmission Replacement
WARNING: This page is about a different car, the 2010 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Wiper Transmission
GM1614757Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove both wiper arms. Refer to Windshield Wiper Arm ReplacementΒ .
  2. Remove the air inlet grille. Refer to Air Inlet Grille Panel ReplacementΒ .
1 Front Windshield Wiper Motor Bolt (Qty: 3)
CAUTION: Refer to Fastener Caution .

Tighten:Β  7 N.m (62 lb in)

2 Windshield Wiper Transmission Assembly
Procedure:Β 
Remove the windshield wiper motor. Refer to Windshield Wiper Motor ReplacementΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.