Cellular and Navigation Antenna Assembly Replacement

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Cellular and Navigation Antenna Assembly Replacement
WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cellular & Navigation Antenna
GM1548459Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedures:Β 
Lower the front of the headliner. Refer to Headlining Trim Panel Replacement .
1 Vehicle Transceiver Bolt
NOTE: Refer to Fastener Notice .

Tighten:Β  9 N.m (80 lb in)

2 Vehicle Communication Transceiver Assembly
Tip:Β  Disconnect the electrical connectors.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.