Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 256 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WIPER MOTOR REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet HHR LT, 2.4 P, Automatic
Removal Procedure
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
- Remove the windshield wiper transmission. Refer to Windshield Wiper Transmission Replacement .
- Remove the wiper crank arm nut.
- Remove the wiper crank arm from the wiper motor.
- Remove the wiper motor screws.
- Remove the wiper motor from the wiper transmission assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.