SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 255 (CELLULAR SYSTEMS, ENTERTAINMENT SYSTEMS & NAVIGATION SYSTEMS)REPAIR INSTRUCTIONSDIGITAL RADIO RECEIVER REPLACEMENT
2008 Chevrolet HHR LT, 2.4 P, Automatic

Digital Radio Receiver Replacement

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Digital Radio Receiver Replacement
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Receiver - Digital Radio
GM1545957Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the rear shelf trim panel. Refer to Rear Window Shelf Trim Panel Replacement .
1 Digital Radio Receiver Assembly
Tip: 
  • Disconnect the electrical connectors.
  • Perform the digital radio receiver set up procedure. Refer to Control Module References for programming and setup information.
2 Digital Radio Receiver Screw
CAUTION: Refer to Fastener Caution .

Tighten:  9 N.m (80 lb in)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.