SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 238 (FIXED AND MOVEABLE WINDOWS SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet HHR LT, 2.4 P, Automatic

Removal Procedure

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
  1. Open the hood.
  2. Remove the antenna, if equipped. Refer to Radio Antenna Replacement .
  3. Remove the windshield wiper arms. Refer to Windshield Wiper Arm Replacement .
  4. Remove the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
  5. Remove the inside rearview mirror. Refer to Inside Rearview Mirror Replacement .
    6. WARNING: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
  6. Cover to protect the following parts from broken glass:
    • The upper dash pad
    • The defroster outlets and A/C outlets
    • The seats and carpeting
    7. Fig 1: Identifying Lower Windshield Supports
    GM326804Courtesy of GENERAL MOTORS CORP.
  7. Remove the lower windshield supports (1) from the cowl panel, if equipped.
    8. WARNING: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.