SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 238 (FIXED AND MOVEABLE WINDOWS SYSTEM)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REPLACEMENT
2008 Chevrolet HHR LT, 2.4 P, Automatic

Front Side Door Window Replacement

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Front Side Door Window Replacement
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Window Replacement - Front Door
GM1548191Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the front side door trim panel. Refer to Front Side Door Trim Panel Replacement .
  2. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
1 Front Side Door Window Insulators Retainer Clip (Qty: 2)
Procedure: 
Place the window about half way down this will allow the insulators retainer clips to be viewed.
2 Front Side Door Window Sash

Procedures

  1. Push in on each end of the window insulators retainer clips.
  2. Slide the sash forward releasing the window from the retainer clips complete.

Tip:  Do not remove the sash from the window regulator.
3 Front Side Door Window

Procedures

  1. Rotate the window downward, pull upward removing the window from the door.
  2. Slide the sash rearward locking the window insulators retaining clips, then inspect the door window for proper operation and alignment before installing the door trim panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.