Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 235 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC 5045CIRCUIT/SYSTEM TESTING
2008 Chevrolet HHR LT, 2.4 P, Automatic
Circuit/System Testing
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The PPS is a calibrated unit. When replacing the assembly all parts in the service it must remain together. Do not mix any of the old part with the new parts. The PPS service kit contains, seat foam, pressure sensor and PPS module (if applicable).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.