SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 23 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSWHEEL STUD REPLACEMENT (4-STUD PATTERN)REMOVAL PROCEDURE
2008 Chevrolet HHR LT, 2.4 P, Automatic

Removal Procedure

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Stud (4-Stud Pattern)
    GM900968Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Without disconnecting the hydraulic brake flex hose, remove and support the brake caliper and bracket as an assembly, and remove the brake rotor. Refer to Front Brake Rotor Replacement (Without RPO LNF) or Front Brake Rotor Replacement (With RPO LNF) .
  4. Inspect the head of the wheel stud to be replaced, to determine if the stud is an original, round-head, or a service replacement, D-shape head.
    5. IMPORTANT: It will be necessary to cut off a portion of an original, round-head wheel stud in order to provide clearance to remove the stud from the wheel bearing hub.
  5. If an original, round-head wheel stud is to be replaced, then a portion of the stud must be cut off, so that the remainder of the stud will be approximately 10 mm (0.39 in) long from the face of the bearing hub flange.
  6. Rotate the bearing hub to a position where the least amount of interference between the stud and the steering knuckle exists.
  7. Using the J 43631  , release the wheel stud from the bearing hub. If a portion of the stud was cut off, remove and discard the stud.
  8. Loosen the 3 wheel bearing/hub assembly mounting bolts evenly, until there is approximately 7 mm (1/4 in) of clearance between the seat of the bearing assembly and the steering knuckle. This will be necessary for removing and installing a service replacement D-shape head stud.
  9. If the stud being replaced was a D-shape head, remove and discard the stud.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.