SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 217 (NAVIGATION SYSTEM)DTC TROUBLESHOOTINGDTC 1307: DVD READ ERROR
2008 Chevrolet HHR LT, 2.4 P, Automatic

DTC 1307: DVD Read Error

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION DTC 1307: DVD Read Error
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Check the vehicle battery condition first (see 12 VOLT BATTERY TEST ).
  • This navigation DTC sets when the navigation DVD is severely scratched or dirty, or if the navigation unit's DVD drive is malfunctioning.
  • Make sure the correct DVD version is installed.
  • Check any official Honda service website for more information about the navigation system.
  • Before you troubleshoot, make sure to follow the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION  ).
  • Inspect the navigation DVD for scratches, damage, or wrong version. Refer to any official Honda service website for more information about navigation software versions.
  1. Turn the ignition switch to ON (II).

    Is there a DVD error message? 

    YES  -Go to DVD screen error messages (see ERROR MESSAGE TABLE  ).

    NO  -Go to step 2.

  2. Clear the hard error code (see HOW TO CLEAR ERROR HISTORY ).
  3. Turn the ignition switch to LOCK (0) and then back to ON (II).
  4. Check for the hard error code (see HOW TO CHECK ERROR HISTORY ).

Is DTC 1307 indicated? 

YES  -Replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION  ).

NO  -Intermittent failure, the system is OK at this time. If the unit repeatedly comes back with the DTC, replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION  ).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.