Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 213 (POWER WINDOWS)POWER WINDOW MASTER SWITCH REPLACEMENT
2008 Chevrolet HHR LT, 2.4 P, Automatic
Power Window Master Switch Replacement
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Power Window Master Switch Replacement
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the armrest trim (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
- Remove the switch panel from the door panel.
- Disconnect the 22P connector (A) from the power window master switch (B).
- Remove the four screws and the switch (A).
- Install the switch in the reverse order of removal.
- After replacement, reset the power window control unit (see RESETTING THE POWER WINDOW CONTROL UNIT ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.