SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 204 (DASHBOARD)SIDE DEFOGGER VENT TRIM REMOVAL/INSTALLATION
2008 Chevrolet HHR LT, 2.4 P, Automatic

Side Defogger Vent Trim Removal/Installation

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Side Defogger Vent Trim Removal/Installation
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required 

KTC Trim Tool Set SOJATP2014*

*Available through the Honda Tool and Equipment Program, 888-424-6857

NOTE:
  • Take care not to scratch the dashboard and its related parts.
  • Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
  • The left side defogger trim is shown; the right side defogger trim is similar.
  1. Insert the appropriate trim tool in the gap between the side defogger vent trim (A) and the dashboard, and detach the hooks (B), then remove the trim.
    NOTE: Apply protective tape (C) to the body as shown.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.