Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 200 (TIRE PRESSURE MONITORING SYSTEM)TIRE PRESSURE SENSOR REPLACEMENTINSTALLATION

2008 Chevrolet HHR LT, 2.4 P, Automatic

Tire Pressure Sensor Replacement: Installation

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Installation

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Use only wheels that have a "TPMS" stamp (A) on the inside of the aluminum wheels, and the outside of the steel wheels.
The vehicle may be equipped with either aluminum wheels, or steel wheels.

Aluminum wheel

Fig 1: Identifying "TPMS" Stamp On Inside Of Aluminum Wheels

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Steel wheel

Fig 2: Identifying "TPMS" Stamp On Inside Of Steel Wheel

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Before installing the tire pressure sensor, clean the mating surfaces on the sensor and the wheel.
Install the tire pressure sensor (A) and the washer (B) to the wheel (C), and tighten the valve stem nut (D) finger tight. Make sure the pressure sensor is resting on the wheel.
NOTE: Install the tire pressure sensor so that the sensor housing surface (E) does not extend beyond the protrusion (F) on the wheel to prevent the sensor housing from being caught on the bead of the tire when assembling the tire.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.