Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 183 (EXTERIOR TRIM)EMBLEM/STICKER REPLACEMENT
2008 Chevrolet HHR LT, 2.4 P, Automatic
Emblem/Sticker Replacement
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Emblem/Sticker Replacement
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When removing the emblems/sticker, take care not to scratch the body.
- To remove the front "H" emblem, remove the upper front bumper grille (see UPPER FRONT BUMPER GRILLE REPLACEMENT ).
- To remove the rear "H" emblem, remove the rear license trim (see REAR LICENSE TRIM REPLACEMENT ).
- Clean the body surface with a sponge dampened in isopropyl alcohol. After cleaning, keep oil, grease, and water from getting on the surface.
- Apply the emblems/sticker where shown.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.