SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 163 (CONVENTIONAL BRAKE COMPONENTS)CONVENTIONAL BRAKE COMPONENTSBRAKE HOSE REPLACEMENTREAR
2008 Chevrolet HHR LT, 2.4 P, Automatic

Brake Hose Replacement: Rear

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Rear
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle.
  2. Remove the rear wheel.
  3. Disconnect the brake hose (A) from the brake line (B) using a 10 mm flare-nut wrench (C).
    Fig 1: Identifying Brake Hose And Brake Line
    G06430740Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove and discard the brake hose clips (A) from the brake hose (B).
    Fig 2: Identifying Brake Hose Clips And Brake Hose
    G06430741Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the brake hose from the brake hose bracket (C).
  6. Install the brake hose (A) through the brake hose bracket (B).
    Fig 3: Identifying Brake Hose And Brake Hose Bracket
    G06430742Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Connect the brake line (A) to the brake hose (B) loosely.
    Fig 4: Connecting Brake Line With Torque Specifications To Brake Hose
    G06430743Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Install the new brake hose clips (C) on the brake hose.
  9. Tighten the 10 mm flare nut (D) to the specified torque values.
  10. After installing the brake hose, bleed the brake system (see BRAKE SYSTEM BLEEDING  ).
  11. Do the following checks:
    • Check the brake hose and line joint for leaks, and tighten if necessary.
    • Check the brake hose for interference and twisting.
  12. Clean the mating surfaces of the brake drum and the inside of the wheel, then install the rear wheel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.