Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P0602 (91): Motor Control Module (MCM) Programming Error; DTC P0602 (92): Motor Control Module (MCM) Program Not Installed (Battery Condition Monitor Program)
- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).
- This DTC is indicated when an MCM update is not completed.
- Do not turn the ignition switch to ACC (I) or to LOCK (0) while updating the MCM. If you do, the MCM can be damaged.
- If the DTC cannot be cleared, do the troubleshooting for DTC U1204 (55).
- Turn the ignition switch to ON (II).
- Clear the DTC with the HDS (see DTC CLEAR ).
- Do the MCM update procedure (see MOTOR CONTROL MODULE (MCM) UPDATE ).
- Check for Pending or Confirmed DTCs with the HDS.
Is DTC P0602 indicated?
YES -Replace the original MCM (see MOTOR CONTROL MODULE (MCM) REMOVAL/INSTALLATION ), then go to step 1.
NO -Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.