Installation Procedure

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2009 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sunroof Air Deflector
    GM1704613Courtesy of GENERAL MOTORS CORP.
  1. Position the sunroof air deflector (2) to the sunroof module.
  2. CAUTION: Refer to Fastener Caution .
  3. Install the screws (1) that attach the sunroof air deflector (2) to the sunroof module.

    Tighten:Β  Tighten the screws to 3 N.m (26 lb in).

  4. Install the air deflector actuators to each side of the window tracks.
  5. Verify that the spring action of the sunroof air deflector is operating.
  6. Close the sunroof window.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.