Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 109 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSELECTRONIC POWER STEERING MOTOR CONTROL MODULE REPLACEMENT (SS)INSTALLATION PROCEDURE

2008 Chevrolet HHR LT, 2.4 P, Automatic

Installation Procedure

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Installation Procedure

WARNING: This page is about a different car, the 2009 Chevrolet HHR. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Electronic Power Steering Motor Control Module Bracket & Bolts

Courtesy of GENERAL MOTORS CORP.

Position the electronic power steering motor control module and bracket (2) together.

CAUTION: Refer to Fastener Caution .

Install the electronic power steering motor control module bolts (1).
Tighten: Tighten the bolts to 11.5 N.m (102 lb in).

Fig 2: Identifying Electronic Power Steering Motor Control Module Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

Install the electronic power steering motor control module and bracket to the vehicle.
Install the electronic power steering motor control module bracket bolts (1).
Tighten: Tighten the bolts to 11.5 N.m (102 lb in).
Connect the electronic power steering motor control module electrical connectors.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.