Inflatable Restraint Steering Wheel Module Coil Replacement

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Inflatable Restraint Steering Wheel Module Coil Replacement
WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Inflatable Restraint Steering Wheel Module Coil
GM2085980Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the steering wheel. Refer to Steering Wheel Replacement
  2. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
1 Inflatable Restraint Steering Wheel Module Coil Bolt (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:Β  1.5 N.m (13 lb in)

2 Inflatable Restraint Steering Wheel Module Coil

Procedure

  1. Disconnect any electrical connectors as needed.
  2. If re-centering of the inflatable restraint steering wheel module coil is needed then refer to Inflatable Restraint Steering Wheel Module Coil CenteringΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.