Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 10 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC 063CIRCUIT/SYSTEM TESTING
2008 Chevrolet HHR LT, 2.4 P, Automatic
Circuit/System Testing
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Ignition ON, clear all SIR and PPS DTCs. Refer to Passenger Presence System Flash Code Procedures . Rezero the PPS using the Passenger Presence System Rezeroing procedure. Verify DTC 063 does not reset.
- If DTC 063 resets, replace the PPS module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.