SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISBRAKESANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEMREPAIR INSTRUCTIONSBRAKE PRESSURE MODULATOR VALVE BRACKET REPLACEMENT (WITH JL4)INSTALLATION PROCEDURE
2008 Chevrolet HHR LT, 2.4 P, Automatic

Installation Procedure

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Installation Procedure
    Fig 1: Upper BPMV Bracket Bolts
    GM1910388Courtesy of GENERAL MOTORS CORP.
  1. Install the BPMV bracket.
  2. Install the 2 upper BPMV bracket bolts (1).
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the BPMV bracket bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    4. Fig 2: Brake Pressure Modulator Valve (BPMV) Bolt
    GM1910377Courtesy of GENERAL MOTORS CORP.
  4. Install the BPMV to the bracket by pressing the BPMV mounting pins into the bracket insulators until fully seated.
  5. Install the BPMV bolt (1).

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

  6. Install the brake pipes to the retainer on the wheelhouse panel.
  7. Install the cover to the ECM and the TCM.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.