Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISBRAKESANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC C0110CONDITIONS FOR RUNNING THE DTC
2008 Chevrolet HHR LT, 2.4 P, Automatic
Conditions for Running the DTC
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Conditions for Running the DTC
C0110 04
- The ignition switch is in the ON position.
- Initialization is complete.
C0110 61
- The test is initiated once per ignition cycle, when the vehicle speed is greater than 8 km/h (5 mph), and a fault was set on the last ignition cycle.
- The vehicle speed is greater than 20 km/h (13 mph), and the brake is not applied.
- The vehicle speed is greater than 40 km/h (26 mph).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.