Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEIGNITION SWITCH/STEERING LOCKIMMOBILIZER SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC B3031CIRCUIT/SYSTEM VERIFICATION
2008 Chevrolet HHR LT, 2.4 P, Automatic
Circuit/System Verification
2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Circuit/System Verification
IMPORTANT:
When performing a 10 Minute Relearn Procedure, all keys not learned at that time will be erased and not be recognized. Perform the Adding Keys procedure on all keys or instruct the customer how to perform the Adding Keys procedure should all vehicle keys not be present at the time of repair.
- Verify DTC B3060 is not set as current.
- If DTC B3060 is set as current, refer to DTC B3060 .
- Perform the 10 Minute Vehicle Key Relearn procedure. Refer to Replacing Keys (North America except Canada) or Replacing Keys (Canada) . The TDM should exit learn mode and DTC B3031 should clear.
- If the TDM does not exit learn mode, replace the TDM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.