Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINSTRUMENT PANEL TRIM AND CONSOLE TRIMREPAIR INSTRUCTIONSFRONT FLOOR CONSOLE REPLACEMENT

2008 Chevrolet HHR LT, 2.4 P, Automatic

Front Floor Console Replacement

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Front Floor Console Replacement

Fig 1: Front Floor Console Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the console accessory switch mount plate. Refer to Front Floor Console Accessory Switch Mount Plate Replacement . Apply the parking brake. Place the shifter in the neutral position.
1	Front Floor Console Screws (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
2	Front Floor Console ( Console Trim Plate ) Tip: Disconnect the electrical connector.
3	Retainer Clips (Qty: 3)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.