Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM & WASHER SYSTEMREPAIR INSTRUCTIONSWINDSHIELD WIPER MOTOR REPLACEMENT

2008 Chevrolet HHR LT, 2.4 P, Automatic

Windshield Wiper Motor Replacement

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Windshield Wiper Motor Replacement

Fig 1: Wiper Motor

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Preliminary Procedures

Remove the wiper transmission assembly. Refer to Windshield Wiper Transmission Replacement .
Disconnect the wiper motor electrical connector.

Windshield Wiper Motor Bolt (Qty: 3)

NOTE: Refer to Fastener Notice .

Tighten: 6 N.m (53 lb in)

Windshield Washer Wiper Motor

Procedure

Do not apply electrical power to a new wiper motor prior to installation of that motor.
Use the J 39232 or equivalent to separate the transmission arm from the wiper motor crank arm pivot. See Special Tools .
Use the J 39232 or equivalent to separate the transmission arm from the wiper motor crank arm pivot. See Special Tools .
Use the J 39529 or equivalent to install the transmission arm onto the wiper motor crank arm pivot. See Special Tools .
Align the wiper motor crank arm in alignment with the transmission arm links.

Special Tools

J 39232 Wiper Linkage Separator. See Special Tools .
J 39529 Wiper Linkage Installer. See Special Tools .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.