Rear Window Wiper Motor Replacement

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Rear Window Wiper Motor Replacement
Fig 1: Wiper Motor Replacement - Rear
GM1614756Courtesy of GENERAL MOTORS CORP.
Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:Β  Refer to Fastener Tightening SpecificationsΒ .

Preliminary Procedure

  1. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
  2. Remove the rear wiper arm assembly. Refer to Rear Window Wiper Arm ReplacementΒ .
1 Bolt, Rear Window Wiper Motor (Qty: 3)

Tighten:Β  5 N.m (44 lb in)

2 Seal, Rear Window Wiper Pivot Shaft
3 Motor Assembly, Rear Window Wiper
Tip:Β  Pull motor rearward to access washer hose and electrical connections, lower motor into liftgate and remove from exterior pivot shaft seal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.