Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LS, AUTOMATICREPAIR AND DIAGNOSISSTEERINGSTEERING WHEEL & STEERING COLUMNREPAIR INSTRUCTIONSTURN SIGNAL MULTIFUNCTION SWITCH REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet HHR LS, Automatic
Removal Procedure
2008 Chevrolet HHR LS, AutomaticSECTION Removal Procedure
- Remove the instrument panel cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
- Remove the lower steering column trim cover bolts and remove the upper steering column trim cover. Refer to Steering Column Trim Covers Replacement .
- Disconnect the turn signal multifunction switch electrical connectors.
- Position the left lower steering column trim cover out of the way,
- Depress the switch locking tabs and remove the turn signal multifunction switch (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.