Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LS, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (ENGINE CONTROLS AND FUEL - 2.0L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSCRANKSHAFT POSITION SENSOR REPLACEMENTINSTALLATION PROCEDURE
2008 Chevrolet HHR LS, Automatic
Installation Procedure
2008 Chevrolet HHR LS, AutomaticSECTION Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Lubricate the CKP sensor O-ring seal with clean engine oil.
- Install the CKP sensor.NOTE: Refer to Fastener Notice .
- Install the CKP sensor bolt.
Tighten: Tighten the sensor bolt to 10 N.m (89 lb in).
- Connect the engine wiring harness electrical connector (1) to the CKP sensor.
- Install the starter. Refer to Starter Motor Replacement .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.