Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2008 Chevrolet HHR LS, AutomaticSECTION Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Lubricate the oil level indicator tube O-ring seal with lubricant. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Install the oil level indicator tube to the engine block.
- Install the oil level indicator tube bolt.
Tighten: Tighten the bolt to 10 N.m (89 lb in).
- Install the vacuum hose (2) to the oil level indicator tube.
- Install two wire harness clips (1) to the oil level indicator tube bracket.
- Install the CAC outlet pipe. Refer to Charge Air Cooler Outlet Pipe Replacement .
NOTE:
Refer to Fastener Notice
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.